Response from Jonathan: Jeremiah,

It sounds like you’re experiencing some sort of sync issue with your Golden Tee Complete 2005 monitor. It’s possible that the sync wire that runs from your board to your monitor is not making a good connection. It could have come out of the connector, it could have been cut or damaged over time, the pin that the wire connects to could need some solder touch up on the monitor chassis, etc. Make sure you check these areas for issues. If you do end up removing the monitor chassis from your cabinet, you might try looking for cracked or cold solder joints on it while you have it out as these can cause issues such as this.

If the problem continues after checking the sync wire and touching up bad solder joints then it’s possible that some electronics parts could have died on your monitor chassis. It’s hard to know exactly which parts without knowing the brand and model of your monitor. At this point, you might try looking on the monitor chassis for this information or you could try comparing your chassis to the pictures on the What’s My Monitor page by Bob Roberts. Please let us know what monitor chassis you have and we’ll try to give you a better diagnosis of what’s going on with it.

Hope that helps. Thank you for your question and good luck with your repair.